32-1245

4095 - Features feramic discs, stainless rivets and long splines for quality and performance. Recommended for competition use only. 200mm 4 Puck Race Disc with Spring Hub

32-1246 - 6 Ceramic pads. 200mm with steel riveted hub.

32-1248 - The brass woven lining really takes the heat. The spring steel hub is sandwiched with dampening material to absorb vibration. Couple with a Kennedy pressure plate for the perfect street or strip set-up. 200mm Kush-Lok Clutch Disc

4085 - Spring steel center disc dampens disc action for a smoother engagement. The metal woven lining resists slip under heavy clamp loads to put horsepower to the ground. 200mm Super Duty Clutch Disc

32-1415

32-1416 - 215mm Cushlock disc with solid hub.

32-1247 - 228mm 9" 6 Puck VW Spline Race Disc. Features 6 feramic pads and rigid hubs.

32-1005 - Slave Saver for Bus transmissions using a CNC slave. The bracket is machined from a billet piece of 6061 T6 aluminum and is fully polished. The slave heim has a 5/16 hole for use with a CNC slave. If you are using an Empi, Jamar, or Latest Rage slave, refer to part number 32-1015.

32-1012 - Slave Saver for Type 1 transmissions using a CNC slave and aftermarket side covers (This can be used with stock side covers but a bump on the cover will have to be ground down, or the bracket can be shimmed out with washers). The bracket is machined from a billet piece of 6061 T6 aluminum and is fully polished. The slave heim has a 5/16 hole for use with a CNC slave. If you are using an Empi, Jamar, or Latest Rage slave, refer to part number 32-1016.

32-1015 - Slave Saver for Bus transmissions using an Empi, Jamar, or Latest Rage slave. The bracket is machined from a billet piece of 6061 T6 aluminum and is fully polished. The slave heim has a 3/8 hole for use with an Empi, Jamar, or Latest Rage slave. If you are using a CNC slave, refer to part number 32-1005.

32-1016 - Slave Saver for Type 1 transmissions using an Empi, Jamar, or Latest Rage slave and aftermarket side covers (This can be used with stock side covers but a bump on the cover will have to be ground down, or the bracket can be shimmed out with washers). The bracket is machined from a billet piece of 6061 T6 aluminum and is fully polished. The slave heim has a 3/8 hole for use with an Empi, Jamar, or Latest Rage slave. If you are using a CNC slave, refer to part number 32-1012.