64-0114 - 2" spindle for custom built A-arm front end. Comes with hubs, rotors, calipers (4 piston), spindles, spindle nuts, brake pads, bearings, seals, lug nuts, and wheel studs. Proudly made here in Santa Fe Springs, CA.

64-1025 - This rack and pinion is designed for A-arm front steer medium sized vehicles. It has a 1 1/4" rack gear with a 1 1/4" pinion and has a 1 1/2 to 1 ratio. It is fully polished and requires 1/2" heim thru hole. This rack is fully closed and machined from 6061 T6 aluminum. This rack, just like all of our other racks, is proudly made here in Santa Fe Springs, CA. (Distance between tie rod heims is 11 inch spread on the bar) This rack has a 3/4" 48-Spline pinion gear.

Magnum Front Steer A-Arm Rack & Pinion--These racks are just like our front steer A-arm racks for light weight sand cars with minimal travel, but are built to take the abuse of heavier vehicles looking to use the same set-up. The housings are black anodized for wear and the tie rod eyelets are 16" apart. The rack gear is also wider than the 64-1022SU, making it strong enough to handle the heavier weight. Comes with clevis ends. This rack has a 3/4" 48-Spline pinion gear.

64-4147 - Our newest addition to our billet aluminum products. This pulley is considered a power pulley because it has a larger diameter than a stock pulley, which slows the fan down and creates more horsepower. This pulley has been dyno-test proven to add an extra 2 horsepower to a stock 1600cc engine over the stock alternator/generator pulley! The diameter of the pulley is 4.950" and has been lightened to weigh the same as a stock steel pulley. Just like the other pulleys we make, these are made out of billet 6061 T6 aluminum and are hard anodized for wear. Comes with bonnet, washer, chrome nut, and shims. *This pulley is recommended for off-road use only because of the reduction in cooling*

31-2713 - Billet oil filter adapter. Show quality, ideal for show cars and applications where stronger adapters are needed. Comes with necessary hardware. Made from 6061 T6 aluminum here in Santa Fe Springs, CA and comes fully polished.

71-3373 - This side by side dual exhaust system is ideal for fiberglass manx buggies and will clear dual manifolds. For 1200cc - 1600cc. Buggy Dual Exhaust, Black with Chrome Tips, w/o Heater Box

71-3709 - Dual style exhaust features great looks and maximum horsepower. Slip-joints allow for easy installation. Eliminates heater boxes. Fits 1200-1600cc engines with single carburetor.

17-2562 - This kit is needed when you are plumbing your Charlynn torque generator. Supplied with hardware and fittings.

17-2561 - Charlynn Shaft Key Way, Each

64-4121 - For the heavy off road machines with large front tires. This unit installs before the steering box to provide power steering to your sand or off road race car.

17-2603 - This weld-in bracket bolts to the Charlynn torque generator for a clean installation.

32-1546 - Worn-out and defective flywheels can cause a host of problems, from leaking crankshaft seals to broken starter drive gears to clutch chatter and failure. This flywheel is manufactured to exacting specifications from high grade steel and balanced. Stock, 200mm, 12-volt, 130 teeth, O-ring style. Fits Type 1/2/3 1300cc-1600cc. Each.